Differences

This shows you the differences between two versions of the page.

--- 3dprinting:prusai3mk25 [2019-10-28 01:23] – xro
+++ 3dprinting:prusai3mk25 [2025-11-09 09:25] (current) – external edit 127.0.0.1
@@ Line 8: / Line 8: @@
   * 2019-10-28:
     * works and prints beautifully without problems or issues or things that needed fixing (tested with PrusaSlicer and SD-Card)
-    * filament sensor PAT9125 does not work and needs to be disabled in firmware
+    * filament sensor PAT9125 works with MK25 firmware and correctly detects broken or run-out filament
-      * either sensor is dead or not supported in MK2.5 Firmware, since prusa only sells this type for MK3
+    * print bed adhesion is good if nozzle is cleaned beforehand.
 ==== Resources ====
@@ Line 25: / Line 25: @@
   - Slice a ''.stl''
-  - Print using SD-Card or via USB
+  - Pre-Print check
+  - Print ''.gocde'' using SD-Card or via USB
 === Slice ===
@@ Line 34: / Line 36: @@
     - Slice
   - Save GCODE to Disk
+=== Pre-Print Check ===
+  * Clean print-bed
+  * Check removable magnetic steel-print-bed is flat and correctly seated
+  * Carefully clean nozzle while nozzle is in the air and half-way heated by using cool metal pliers and removing softened filament without scratching anything
+  * Check you have the right  filament inserted (the one you sliced for)
 === Print using SD-Card ===