on loan

• 2019-10-28:
  • works and prints beautifully without problems or issues or things that needed fixing (tested with PrusaSlicer and SD-Card)
  • filament sensor PAT9125 works with MK25 firmware and correctly detects broken or run-out filament
  • print bed adhesion is good if nozzle is cleaned beforehand.

• Manual
• Prusa Slicer
• Firmware
  • on website choose Original Prusa i3 MK2.5 (do NOT choose MK2.5S as it supports a *different* filament sensor)
  • from archive choose file which ends in RAMBo13a_en-de.hex
• Prusa Help Knowledge Database
  • FINDA Sensor
  • PINDA Probe

1. Slice a .stl
2. Pre-Print check
3. Print .gocde using SD-Card or via USB

1. Use PrusaSlicer on Würfel
   1. Select the Prusa i3 MK2.5 Profile
   2. Select Material (probably PrusamentPETG)
   3. Slice
2. Save GCODE to Disk

• Clean print-bed
• Check removable magnetic steel-print-bed is flat and correctly seated
• Carefully clean nozzle while nozzle is in the air and half-way heated by using cool metal pliers and removing softened filament without scratching anything
• Check you have the right filament inserted (the one you sliced for)

1. Eject SD-Card from Printer and put into Würfel
   1. if SD-Card Reader on front of Würfel does not work, disconnect and reconnect USB-Cable
2. Copy to SD-Card
3. Unmount SD-Card
4. Plug SD-Card back into Printer
5. Start print from SD-Card in printer menu

1. Start Pronterface (Pronsole in Graphics Menu)
2. Load .gcode file saved earlier
3. ensure USB-cable is connected
4. Start print

TODO