Differences

This shows you the differences between two versions of the page.

--- 3dprinting:prusai3mk25 [2019-10-28 00:58] – xro
+++ 3dprinting:prusai3mk25 [2025-11-09 09:25] (current) – external edit 127.0.0.1
@@ Line 8: / Line 8: @@
   * 2019-10-28:
     * works and prints beautifully without problems or issues or things that needed fixing (tested with PrusaSlicer and SD-Card)
-    * filament sensor PAT9125 does not work and needs to be disabled in firmware
+    * filament sensor PAT9125 works with MK25 firmware and correctly detects broken or run-out filament
-      * either sensor is dead or not supported in MK2.5 Firmware, since prusa only sells this type for MK3
+    * print bed adhesion is good if nozzle is cleaned beforehand.
 ==== Resources ====
@@ Line 22: / Line 22: @@
     * [[https://help.prusa3d.com/article/3tSXh6nWJd-pinda-probe-testing | PINDA Probe]]
-==== How To Print (recommended way) ====
+==== How To Print ====
+  - Slice a ''.stl''
+  - Pre-Print check
+  - Print ''.gocde'' using SD-Card or via USB
+=== Slice ===
   - Use PrusaSlicer on Würfel
@@ Line 28: / Line 35: @@
     - Select Material (probably PrusamentPETG)
     - Slice
-  - Save GCODE to SD-Card
+  - Save GCODE to Disk
+=== Pre-Print Check ===
+  * Clean print-bed
+  * Check removable magnetic steel-print-bed is flat and correctly seated
+  * Carefully clean nozzle while nozzle is in the air and half-way heated by using cool metal pliers and removing softened filament without scratching anything
+  * Check you have the right  filament inserted (the one you sliced for)
+=== Print using SD-Card ===
+  - Eject SD-Card from Printer and put into Würfel
     - if SD-Card Reader on front of Würfel does not work, disconnect and reconnect USB-Cable
-  - Print from SD-Card
+  - Copy to SD-Card
-    - (after plugging SD-Card back into printer)
+  - Unmount SD-Card
+  - Plug SD-Card back into Printer
+  - Start print from SD-Card in printer menu
+=== Print via USB ===
+  - Start Pronterface (Pronsole in Graphics Menu)
+  - Load ''.gcode'' file saved earlier
+  - ensure USB-cable is connected
+  - Start print
+=== Print via Octoprint ===
+TODO
 ====== Specs and Settings ======