Differences

This shows you the differences between two versions of the page.

--- xro:lothrelectronicsstation [2019-01-13 03:52] – xro
+++ xro:lothrelectronicsstation [2025-11-09 09:25] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
+{{tag>project}}
 ===== LoTHR mini Electronics Soldering Station =====
@@ Line 7: / Line 8: @@
     * Backside Switch re-used on front
   * [[https://www.thingiverse.com/thing:2817722 | T12 Tip Holder]]
-  * [[https://www.conrad.at/de/schuetzinger-seb-6452-ni-sw-sicherheits-laborbuchse-buchse-einbau-vertikal-stift-o-4-mm-schwarz-1-st-1537941.html| 2x Safety Laboratory Banana Jack]]
+  * [[https://www.conrad.at/de/schuetzinger-seb-6452-ni-sw-sicherheits-laborbuchse-buchse-einbau-vertikal-stift-o-4-mm-schwarz-1-st-1537941.html| 4x Safety Laboratory Banana Jack]]
   * old external SCSI HDD Case
   * 2x 5pin Jumper-Wire Jack
+  * Switching power supply 24V / 3.2A, set to ~27V
+  * [[https://de.aliexpress.com/item/35-watt-elektronische-last-einstellbare-konstante-strom-aging-widerstand-batterie-spannung-kapazit-t-tester-LCD-spannung/32954356498.html | XY-FZ35 Electronic Load]]
+  * 1x USB Serial TTL Converter
+  * 3x Jumper Wires
+=== Manual ===
+[[realraum:minielectronicsworkstationmanual]]
 === Photos ===
 https://galley.realraum.at/index.php?/category/184
+=== Blog Posts ===
+  * https://wp.realraum.at/2019/01/lothr-mini-electronics-workbench/
+  * https://wp.realraum.at/2019/02/lothr-mini-electronics-workbench-upgrade/
 === Front ===
@@ Line 20: / Line 34: @@
 The front was lasercut to accommodate the different devices.
-  * Black: cut with 100% 60W at 7mm/s
+  * Black: cut with 90% 60W at 10mm/s
-  * Red: scan-engraved with 12% 60W at 100mm/s
+  * Red: scan-engraved with 18% 60W at 100mm/s
-{{ :xro:loetstationlabornetzteillothrbox2.svg |}}
+{{ :xro:loetstationlabornetzteillothrbox3.svg |}}