roomauto:howto_integrate_second_otbr_into_homeassistant

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
roomauto:howto_integrate_second_otbr_into_homeassistant [2026-02-27 18:17] – xroroomauto:howto_integrate_second_otbr_into_homeassistant [2026-02-27 18:21] (current) – xro
Line 8: Line 8:
   - use docker-compose (see below) to install these two containers   - use docker-compose (see below) to install these two containers
     * ''ghcr.io/koenkk/zigbee2mqtt''      * ''ghcr.io/koenkk/zigbee2mqtt'' 
-    * ''denniswitt/homeassistant-otbr:latest''+    * ''denniswitt/homeassistant-otbr:latest'' (recommend you don't use the original OTBR docker container.)
   - configure Zigbee2MQTT using it's onboard screen.   - configure Zigbee2MQTT using it's onboard screen.
     * Enable HomeAssistant AutoDiscovery.     * Enable HomeAssistant AutoDiscovery.
 +    * Choose ''/dev/ttyUSBzb'' as radio-device
     * Make sure to use a differnt mqtt-prefix than the other zigbee2mqtt instances     * Make sure to use a differnt mqtt-prefix than the other zigbee2mqtt instances
   - make sure you can see the OTBR multicast DNS broadcasts \\ homeassistant should autodiscover it in the [[http://homeassistant.realraum.at/config/thread|Settings/Threads]] panel   - make sure you can see the OTBR multicast DNS broadcasts \\ homeassistant should autodiscover it in the [[http://homeassistant.realraum.at/config/thread|Settings/Threads]] panel
  • /srv/dokuwiki/data/attic/roomauto/howto_integrate_second_otbr_into_homeassistant.1772216244.txt.gz
  • Last modified: 2026-02-27 18:17
  • by xro