3dprinting:witbox [realraum]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== BQ Witbox (1) ======

==== Manual ====

[[https://www.bq.com/de/support/witbox/support-sheet|Handbücher, Schnellstart und Anleitungen]]

====== Pre-Print Checks ======

<WRAP center round help 60%>

  - Is the removable printbed latched in?
      * if not -> move until it's level and all magnets are connected
  - Is the printbed level?
      * If not –> Select Leveling from Display-Menu, follow instructions and use the three screws below printbed to level.
  - Is the blue-tape on the surface ok?
      * If not –> remove tape-strip that is broken and replace with a new strip. Blue-tape can be found and belongs in in the filament box.
  - Is the filament dustfree? If not –> Clean with cloth or pressured air.
      * Make sure dust does NOT get into the extruder.
      * Print and deploy a [[https://www.thingiverse.com/search?q=filament+cleaner|Filament Cleaner]] if not present
  - Is the filmanet entangled? –> disentangle.
  - Load correct material profile in Cura.
      * If in doubt use "Low definition" since it's fast –> see [[materials|Materials]]

</WRAP>


====== monthly Maintenance ======

TODO

====== supported Materials ======

  * PLA 1.75mm