Differences

This shows you the differences between two versions of the page.

--- 3dprinting:witbox [2019-04-29 03:35] – created xro
+++ 3dprinting:witbox [2025-11-09 09:25] (current) – external edit 127.0.0.1
@@ Line 9: / Line 9: @@
 <WRAP center round help 60%>
+  - Is the removable printbed latched in?
+      * if not -> move until it's level and all magnets are connected
   - Is the printbed level?
-      * If not –> [[#printbed_leveling|Printbed Leveling]]
+      * If not –> Select Leveling from Display-Menu, follow instructions and use the three screws below printbed to level.
-  - Is the surface clean?
+  - Is the blue-tape on the surface ok?
-      * If not –> Clean with alcohol/spirit/glass cleaner
+      * If not –> remove tape-strip that is broken and replace with a new strip. Blue-tape can be found and belongs in in the filament box.
-  - Is the filament dustfree? If not –> Clean with pressured air.
+  - Is the filament dustfree? If not –> Clean with cloth or pressured air.
       * Make sure dust does NOT get into the extruder.
       * Print and deploy a [[https://www.thingiverse.com/search?q=filament+cleaner|Filament Cleaner]] if not present
   - Is the filmanet entangled? –> disentangle.
   - Load correct material profile in Cura.
-      * If in doubt use "Fast" –> see [[#materials|Materials]]
+      * If in doubt use "Low definition" since it's fast –> see [[materials|Materials]]
-  - Are you printing Nylon?
-      * Prep with Glue Stick. Clean/Remove with Water afterwards.
-  - Need to change filament?
-      * Check for difference in extrusion temperature and [[#changing_filaments|follow guide]]
 </WRAP>
 ====== monthly Maintenance ======
+TODO
+====== supported Materials ======
+  * PLA 1.75mm